SKU: N/AThis site contains affiliate links for which we may be compensated
Consumer Electronics / Surveillance & Smart Home Electronics / Home Surveillance / IP & Smart Security Camera Systems
Description= Used Tested Fully working wireless home security alarm system Intertek 2-GIG-GCKIT311. Includes everything you need EXCEPT batteries and cell communicator. See below: Included:
A (Used, but very good condition) Intertek 2-GIG-GCKIT311 panel, tested working and reset to factory defaults, with minor scratches and/or stains possible.
The panel has been flashed with the NEWER version v1.19.1 software which should accept the newer than 3-G cell modules.
There are small scratches on the right side of the panel (see photo)
A (Used) power transformer with connection wire
Seven (Used) tested Honeywell 5816 wireless door/window contacts, with magnets and mounting hardware. (uses CR123A 3 volt batteries, NOT included)
One (Used) tested Honeywell 5808W3 smoke detector (uses CR123A battery, NOT included)
One (Used) tested Honeywell 5890PI motion detector (uses CR123A batteries, NOT included)
One (Used) tested 2GIG-345 remote (uses a 2025 battery, NOT included; a Tested working Used one IS included for FREE and is NOT guaranteed or warranted)
A 7.5v panel system battery is NOT included in this purchase.
(A Tested working Used one IS included for FREE and is NOT guaranteed or warranted. Battery tests at 7.8vdc under load)
NOTE: Ten (Used) CR123A sensor batteries ARE included for FREE and are NOT guaranteed or warranted (they do test at least 3.1 vdc under load)
ALL included sensors have been pre-tested with this panel. In fact ALL sensors have already been programmed into the panel. The door/window sensors are named ‘Sensor 1 thru 7’. Sensors 1 and 2 are entry delay sensors, and 3-7 are instant perimeter sensors. A PDF installation guide is available at: https://2gig.com/wp-content/uploads/10022312_rev-c-gc2e-install-programming-guide_web.pdf
Returns Accepted for this item if it's within 14 Days