Qolsys IQ Hardwire 16-F Wireless Converter (QS7133-840)

Add hardwired security zones to your IQ Panel 2 (or 2+) with the Qolsys IQ Hardwire 16-F Wireless Converter. This security control board increases the amount of sensors and smoke detectors that can be supported in your Qolsys system. The board also provides power sources for multiple input zones, LED status lights, backup battery charging, and a siren relay.

Programmable security control board supports security and smoke detecting zones

Supports up to 10 2-wire smoke detectors and powers up to 15 input zones

Encrypted S-Line technology protects signals while supporting legacy 319.5 systems

LED lights indicate status of each individual zone

Up to 500 Milliamps of power for hardwired motion detectors, glass break detectors, and/or sirens

Charging circuit for back-up battery, fully supervised with power outage recovery

Installation Details
The IQ Hardwire 16-F Wireless Converter comes with a small plastic enclosure for easy mounting. Vertically install the Wireless Converter in your desired location within wireless range of your IQ Panel. Wire in your desired devices and sensors and attach the included antenna to the top of the control panel. Afterwards, pair the Converter with your IQ Panel by press and holding the "EOL LEARN" button on the Converter and placing your IQ Panel into "Auto Learn" mode.
Contents

Wireless Converter

Antenna

Enclosure

NOTE: Not for use with CO detectors.
Technical Details Manufacturer Part #:

QS7133-840

UPC:

857497008039

Input Voltage:

16.0VDC Plug-In Transformer

Backup Battery:

12VDC 5AH Max (optional)

Dimensions:

5.5 H X 3.5 W inches

Operating Temperature:

32 to 122 degrees F (0 to 50 degrees C)

Humidity:

95% RH Max

EOL Supervision:

4.7K Ohm fixed or 1k-10k Ohm depending on Resistor Mode

Input Zones:

15 N/O or N/C (Normally Open/Normally Closed)

Smoke Zone:

1 two-wire smoke loop, 10 detectors max. Support for System Sensor@reg; 2W-B, 2WT-B, 2WTA-B*

Auxiliary Voltage Output:

12VDC @ 500mA Max

Tamper Zone:

Used for case tamper, no resistor

Relay Contact:

60VDC/1A Max drives siren

Returns Accepted for this item if it's within 30 Days